This adhesive is a mixture of cementitious materials with polymer additives and adhesion enhancers and mineral fillers and is ready to use only by adding water.
Properties and effects:
Ultra high adhesion strength
Affordable and suitable for horizontal surfaces
Resistant to moisture
Ease of implementation
Install tile on tile
Wall and floor tiling
Installation of decorative stones, ceramics and mosaics on a variety of surfaces
Depending on the surface under work, the amount of roughness and porosity of the surface is about 2 to 4 kg is required to cover one square meter.
Method of Use:
Before applying the ceramic tile adhesive, make sure that the surface under the work is clean and smooth, then add some water in a container and gently add the powder adhesive to it. When the powder is added to water, the electric mixer is on Continue to be uniform and homogeneous. Leave the ready-made adhesive mortar for 5 minutes. Repeat the mixing operation for a short time, and then draw the adhesive groove on the surface with a spatula and press the tile on it.
After applying the adhesive on the surface, the tile must be installed in a maximum of 20 minutes.
Note: 1 After the difference between the special tile adhesive and water, the prepared dough should be used within 60 minutes according to the ambient temperature, so prepare the adhesive in such a way that it can be consumed during this time.
Initial adhesion resistance more than .50.5mm
Shelf life: one year in the original packaging
Storage conditions: Container in a package away from moisture, frost and direct sunlight
Best storage temperature: +10 to +30 ° C
Packing type: 20 kg bags